Yes. The lid uses a strong magnetic ring that grips MagSafe phones directly, and a booster ring is included for any phone without built-in MagSafe. It holds through most cases and rotates 360 degrees, so you can film or watch in any position.

It works with MagSafe cases out of the box. For non-MagSafe cases, the included booster ring attaches to the back of your phone or case and gives you the same secure hold.

Every bottle ships with a snap lid and at least one magnetic lid. On the product page you choose your magnetic lid style: straw for sipping on the go, or direct drink for a faster flow.

Because this is the founding run. The bottles arrive blank, with no Modus Hold logo printed on the side, and that is on purpose rather than a mistake.

Printing on stainless steel means a pad print or a laser etch. Both need locked artwork and a minimum order about the size of a full production run, and this batch was placed before that was ready. Holding the run back would have meant months of nothing. Everything else about the bottle is final: the 304 steel, the insulation, the lids, the threads and the base pocket are all production parts.

Future runs will carry a properly printed logo. Join the list on the homepage if you would rather wait for a branded one.

Your keys and keyring, earphones out of their case, a card or two, folded cash, lip balm, a hair tie, a few dog treats or tablets.

Think everyday carry rather than a full pocket dump. It holds 80 to 110 ml, 6.5 cm across and 2.5 cm deep. A phone or a charging case won't fit, and because the floor curves slightly, a card sits at a bit of an angle instead of lying flat.

Yes. Both the drinking lid and the base seal fully. You can toss it in a bag without worrying.

Cold for up to 24 hours, hot for up to 12. The double wall vacuum insulation also keeps the outside sweat free, so it will not leave rings on your desk or make your bag wet.

Yes. The inner wall that touches your drink is food grade 304 stainless steel. It is BPA free and independently tested.

32oz (960ml), which is the everyday size most people reach for. It fits most car cup holders.

We engineer with food-safe 304 stainless steel and BPA-free plastics. To ensure optimal performance and remove any factory-fresh scent from the sealed packaging, give your bottle and all lids (including magnetic lids) a thorough wash with warm, soapy water before your first use.

For the internal straw and lid mechanism, soak them in warm water with baking soda or lemon juice for 15 minutes, then rinse well.

After that, the straw is the part that needs the attention. Run a thin straw brush through it once a week and it stays neutral. Leave it a month and it will start reminding you what you have been drinking.

No, and it is a quick fix. New plastic carries a scent, and the straw and lid mechanism hold onto it the longest. The steel is not the culprit, that is 304 stainless and it does not flavour anything.

Wash the bottle and every lid in warm soapy water before the first use. Then soak the straw and lid mechanism in warm water with baking soda or lemon juice for 15 minutes and rinse well. That clears it.

If a taste turns up again months later, it is usually the straw holding onto old coffee or protein rather than the plastic. Same soak, same result. A thin straw brush once a week keeps it from getting that far.

Wash the bottle body by hand or on the top rack. Keep the magnetic lid out of the dishwasher, as heat can weaken the magnet over time. A quick rinse keeps it in top shape.

Yes. We ship across both New Zealand and Australia. Full delivery times are on our shipping page.